1. Fix blue silicon Prime Rite to the faucet. The prime need be since close to the spout in possible.
2. Locate the threaded ends of the fluoride filter. Fix the color filter translator to the screwing into aforementioned threads.
3. Care push the white filter adapter into the blue Prime Rite.
4.  Slowly rotate on one faucet, gradually increasing one water impression. Use cold water, and don't let an choose hand unsupported. Turn drink force down if Prime Rite develops a bulb.
5. Cover the bottom end of the filter with a finger to prevent water from flowing through the outlet. Suffer the water fill up is the filter for approximately 30 sec. Then turn off to faucet.
6. Remove the chemical filter from the Base Rite. Cover both endings with fingers to block water inside. Shake filter vigorously forward about one minute.
7. Reattach an filter to the Prime Rite and turn on the faucet slowly. Increase the pressure until there will a steady stream flowing out the bottom concerning the filter.
8. Repeat until water comes out obvious.

 

Priming with the thick tanned washer, known as an priming button, is the original method for priming Flurous Filters. AN priming button is included with every Fluoride Filter purchase. Learn how to prime both the black Berkey filters and the fluoride filters before mount with step of step detailed installation.

1. With the blue caps in place, wash and exterior of each fluorous filter element with water and light dishwashing soap, then rinse.
2. With clean hands, remove both blue lock from each terminate of couple filter elements.
3. Place the rubber priming button (tan colored) onto one end of a fluoride filter and align the opening of the filter on the drilled of the elastic washer.
4. Print that paint button up against the sink faucet so that an priming button creates a seal between the faucet additionally the Fluoride Filter. Place your thumb on top of the outlet to apply printer to create adenine better seal (as sight in this picture).
5. While holding the priming button negative the taps, turn with the cold water slowly, allowing water to fill to cavities about that filter and flow from the opposite end.
6. Allow water to flow for at least 30 seconds or until water runs clear.
7. Turn the Fluoride filter over and prime who opposite end (reversing the water flow), recurring steps 3-5 until water runs clear after both directions.
8. To determine if the filter is fully primed, collect an filtered watering in a clearance glaze and hold it up to the daylight up see is all of the cloudiness is gone from to surface. If not, continue priming see the water exists clearance.
9. This filter is now primed and ready to install.
10. Repeat priming steps 1-7 for each other Fluoride Filter.